Formation process of zirconia nanotubes and porous structures and model of oxygen bubble growth

Preparation and growth mechanism of anodization of Ti and Al has been widely concerned for two decades, but the research on anodic ZrO₂ is relatively lacking. In this paper, anodic TiO₂ and ZrO₂ nanotubes were prepared in glycerol electrolyte containing 0.35 M NH₄F and 4 vol% H₂O under different anodizing voltages. We had successfully prepared the anodic ZrO₂ nanotubes (AZNTs) with a complete top and a “bulb” at the bottom under 60 V, and with the increase of the applied anodizing voltage, the “bulb” cavity also increased. However, under the same anodizing conditions, the surface of anodic TiO₂ nanotubes (ATNTs) is a cluster of nano-tip morphology, and the bottom of the ATNTs is a conventional hemisphere shape. In addition, both AZNTs and porous anodic zirconia (PAZ) were found to coexist in the anodic ZrO₂ layer prepared at 60 V. Here, we used the oxygen bubble model and ionic current and electronic current theories to analyze the reason of the special morphology. It is confirmed that the porous anodic oxides are actually evolved from nanotubes. In other words, the structure is essentially the same.     

剪切解络-超滤分离金属关键指标预测与验证

根据剪切解络-超滤过程中金属离子的动态浓度关系和质量守恒定律,采用CodeBlocks17.12软件编写程序,建立了剪切解络-超滤工艺关键指标预测模型,实现了金属离子浓度、回收率、体积稀释倍数等指标的预测,并用实验加以验证。依次在转速800 r/min、1 400 r/min、3 000 r/min下回收模拟废水中43 μg/L的Co²⁺、995 μg/L的Ni²⁺和88 μg/L的La³⁺,3种金属的回收率均达99.8%以上时,超滤过程体积稀释倍数的预测值分别为7.0、7.5、5.75,实验值分别为7.5、7.25、6.25,可见预测值与实验值基本一致。本模型对研究方案制定和调整有实际指导意义。     

Kinetic Monte Carlo simulation of hydrogen production from photocatalytic water splitting in the presence of methanol by 1 wt% Au/TiO2

In this research, using the kinetic Monte Carlo simulation (KMC), the hydrogen production from a water-methanol mixture using Au/TiO₂ photocatalyst is investigated. A mechanism is proposed, and the rate constants of the reaction steps are specified. The reaction rate constants of different steps and the concentration of the active sites on the photocatalyst surface were determined. An excellent match between simulated and experimental data confirms the results. The electron-hole pair production, methanol adsorption on the photocatalyst surface, and electron-hole recombination steps are considered the most critical steps. To study the effects of independent variables (initial concentration of methanol, photocatalyst dosage, pH, and time of reaction) on the produced hydrogen, a combination of KMC simulation and design of experiment was employed. The concentration of photocatalysis has the highest and pH has the lowest effect on the hydrogen production. The optimal conditions for photocatalytic hydrogen production are presented.     

基于ERNIE-BiGRU模型的摘要语步自动识别研究

学术文献的摘要是对文献主要内容的浓缩,摘要不同部分的语步具有不同的信息,语步的自动识别和抽取对于学术摘要的后续研究有着重要的应用价值,而目前语步识别的研究相对较少,并且相关算法的效果还需要提高。针对上述问题,该文提出了一种基于ERNIE-BiGRU模型的语步识别算法。该算法首先结合中文句法分析理论提出基于句法依存关系的多语步结构拆分法,对学术文献摘要多语步结构进行自动拆分,获得多个单语步结构;然后构建用于训练的单语步结构语料库,并利用知识增强语义表示预训练模型,训练出句子级词向量;最后将训练出的单语步结构词向量信息输入双向门限循环单元(BiGRU)进行摘要语步自动化识别,取得了良好的效果。实验结果表明,该算法具有较好的鲁棒性和较高的识别精度,在结构化和非结构化摘要上的识别准确率分别达到了96.57%和93.75%。     

建筑结构控制爆破拆除的力学分析与应用

应用运动学、动力学理论建立建(构)筑物控爆坍落过程的力学模型,进而研究在非定常约束条件下坍落结构的力学特征。首次提出了采用延时起爆技术时,非自由质点系及其广义坐标应是建立在每一段位上的瞬间虚位移。在此基础上,分析求解运动过程中时控单元的质点自由度,为精确选定爆破部位及时序提供了设计理论和计算依据。同时,结合振动理论,将控爆时差、结构载荷分布调制为振动系统,形成坍落结构梁板单元的强迫振动,充分实现在运动中进一步解体、破碎其自身结构,并形成具有明显缓冲效果的下落过程。应用实践结果证明力学分析是正确的,为工程结构爆破拆除计算机辅助设计及动态模拟技术的有效应用奠定了基础。     

基于有限元法的石油射孔枪弹间干扰研究

石油射孔弹顺序起爆后,弹间冲击波相互作用是一个高度非线性的力学过程。基于有限元法对这一过程进行显式动力分析,由计算结果得知,高孔密射孔枪弹间干扰产生的主要原因是下位弹在不对称的压力场起爆。设计的不同孔密和不同爆速的导爆索两种情形的爆轰试验结果表明,弹间间距越小(即孔密的增加),弹间干扰越严重;随着导爆索爆速的降低,下位弹射流头部质量集中的"中间"偏转角度增大,上位弹对其干扰越明显。以上结论可用于高孔密射孔枪的优化设计。     

Effect of heat loss on the syngas production by fuel-rich combustion in a divergent two-layer burner

The effect of heat loss on the syngas production from partial combustion of fuel-rich in a divergent two-layer burner is numerically studied using two-dimensional model with detailed kinetics GRI-Mech 1.2. Both the radiation and wall heat losses to the surrounding are considered in the computations. It is shown that two types heat losses have different effects on the syngas production. The radiation heat loss has significant effect on the syngas temperature and the syngas temperature is dropped as radiation heat loss is increased, but it has neglected effect on the reforming efficiency and methane conversion efficiency. The wall heat loss has a comprehensive effect on the syngas production. The wall heat loss not only reduces the conversion efficiency, but also significantly decreases the syngas temperature. The effect of wall heat loss becomes weak as the equivalence is increased. The reforming efficiency drops from 0.440 to 0.424 for equivalence ratio of 2 and mixture velocity of 0.17 m/s for the predictions between adiabatic wall and non-adiabatic conditions.     

Dynamic simulation of hydrogen-based off-grid zero energy buildings with hydrogen storage considering Fanger model thermal comfort

In this study, some locations with different climates, off-grid zero energy buildings with hydrogen energy storage systems are designed, and transient analysis is conducted. These considered buildings supply their electricity consumption without using the electrical grid and PV panels or wind turbines. Also, they supply thermal comfort to occupants by using a vapor compression chiller and humidifier. Domestic hot water of occupants is supplied using solar collectors. For analyzing building's performance and objectives achievement, TRNSYS software is used. Also, for evaluating occupant thermal comfort, the Fanger model is used. The considered building is a one-story building with a 150 m² area. Four occupants are considered. Both of them are seated at rest, and another is seated with light working such as typing. Using the Fanger model equation and MATLAB software, the thermal comfort of occupants is determined. For domestic hot water consumption, verified profiles that vary during 24 h of the day are considered. Achieved results show that for humid and cold cities, PV panels with an area of 73 and 76 m² can be supplied the required electricity of considered building with four occupants and battery state of charge is higher than 50% and 10%, respectively. Moreover, with a suitable air conditioner system, the predicted percentage of dissatisfied (PPD) can be lower than 12% and 8% for humid and cold cities. Therefore, the building can be converted to a zero-energy building using its rooftop area.     

Double-layer fuzzy adaptive NMPC coordinated control method of energy management and trajectory tracking for hybrid electric fixed wing UAVs

The energy management and trajectory tracking control are crucial to realize long-endurance autonomous flight for hybrid electric UAVs. This study aims to comprehensively consider energy management and trajectory tracking for hybrid electric fixed wing UAVs with photovoltaic panel/fuel cell/battery. A double-layer fuzzy adaptive nonlinear model predictive control method (DFNMPC) is proposed. Separated by the surplus demand power, energy management and trajectory tracking problem are decoupled into the high-layer fuzzy adaptive nonlinear model predictive controll problem (H-FNMPC) and low-layer fuzzy adaptive nonlinear model predictive controll problem (L-FNMPC). H-FNMPC solves the trajectory tracking and navigation control probelm for the greatest benefit of solar energy. L-FNMPC solves the power allocation problem of hybrid energy system for minimum equivalent hydrogen consumption. A fuzzy adaptive prediction horizon adjustment method based on UAV maneuvering degree is proposed to effectively improve proposed method adaptability to different mission profiles. Analogously, a fuzzy adaptive equivalent hydrogen consumption factor adjustment method in L-FNMPC is proposed to ensure the flexible utilization of battery. In addition, an equivalent hydrogen flow rate calculation method based on the real-time current ratio is proposed for PV/FC/Battery hybrid energy system. Numerical simulation results including a spiral trajectory tracking and a quadrilateral trajectory tracking, demonstrate that DFNMPC can simultaneously handle energy management and trajectory tracking problem for hybrid electric UAVs. Compared to hierarchical fuzzy state machine strategy, DFNMPC can save 13.3% hydrogen for the spiral trajectory tracking, and 56.9% for the quadrilateral trajectory tracking. It indicates that the energy efficiency can be improved from both levels of energy management and flight motion. The proposed method prospected for exploring high-energy-efficiency autonomous flight of hybrid electric UAVs in the future.